The latest addition the Concorde series, perfect for all styles of Djing

• Newest addtion to the Ortofon range
• Improved performance
• Good all rounder

Scratching and back-cueing impose heavy mechanical stress on the cantilever and its rubber bearing. Therefore, the Ortofon disco cartridges are equipped with cantilevers made from aluminium tube with increased wall thickness. Special attention has also been paid to the attachment of the bearing and the design of the bearing itself. This means that rough treatment will neither damage the cartridge nor degrade its stability.

For easier cueing, the nose of all the Ortofon disco cartridges has an extra large cut-out which makes the stylus freely visible from above, and further, the tip of the cantilever is fluorescent

Output voltage at 1000 Hz, 5cm/sec.7,5 mV
Channel balance at 1 kHz 1,5 dB
Channel separation at 1 kHz 25 dB
Channel separation at 15 kHz 15 dB
Frequency range at - 3dB 20-22.000 Hz
Frequency response 20-15.000 Hz +3 / -2 dB
FIM distortion at recommended
tracking force, DIN 45.542< 1%
Tracking ability at 315Hz at
recommended tracking force 80 æm
Compliance, dynamic, lateral 6 æm/mN
Stylus type Spherical
Stylus tip radius R 18 æm
Equivalent stylus tip mass 0,6 mg
Tracking force range 3,0-5,0 g (30-50 mN)
Tracking force, recommended 4,0 g (40 mN)
Tracking angle 20ø
Internal impedance, DC resistance 750 Ohm
Internal inductance 450 mH
Recommended load resistance 47 kOhm
Recommended load capacitance 200-600 pF
Cartridge colour, body/stylus White/White
Cartridge weight 18,5 g
Replacement stylus unit Elektro